#Universal type client download mac serial numbers#

For more information about this process, go to Entering serial numbers into Universal Type Server version 7.0.2 or later. The same email address and password you would use to login to. You will need to use your Extensis credentials. The License credentials are the owner or licensee of UTS. Go to Licenses Tab and enter your UTS 7 Extensis license credential.Log in using the Administrator username and password from your previous instance. When the UTS installation is complete the Server Administration web application will open.This is necessary for the private PostgreSQL instance in UTS to start properly if the nf file is modified then you must restart the Mac before attempting to install UTS 7, otherwise PostgreSQL may not start properly during installation and UTS will be unusable.

#Universal type client download mac mac os x#

The Mac OS X installer may change some settings in the /etc/nf file the installer will notify you if changes are made. You can change it after installing UTS 7. IMPORTANT: If you have changed the HTTP client port from 8080 to another port number, the UTS 7 installer will reset it to 8080 during installation.

Restart the server (computer) after the installation of UTS has completed.

If you installed UTS 6 on a volume other than the startup volume, be sure to select the same location for UTS 7.

Download and Launch the UTS 7 installer and follow the prompts.

RECOMMENDATION - Extensis recommends running a backup prior to moving to step 3.

Go to Datastore > Backups and click “Backup now”.

This will put UTS into standby mode until the backup is complete, and users will be unable to connect during the backup process. Perform a backup of your current UTS environment Make sure that the server UTS will be installed on meets the minimum system requirements:

Verify system requirements and supported versions of UTS If moving from a version prior to UTS 6, an alternate recommendation would be to use the following article to back-up the fonts manually and install UTS 7 on a fresh/clean server: Exporting your workgroups, fonts, and sets from Universal Type Server. This requires you to install, configure, serialize and make a backup of each version prior to moving to the next version.Īlternate steps for servers prior to UTS 6 If moving/upgrading from UTS 4, UTS 5 to UTS 7, you will need to perform each version upgrade individually. To move your Universal Type Server to a new server during the upgrade, go to How do I migrate Universal Type Server to another server? This article assumes you will be performing an in-place update of Universal Type Server on the same server. This article describes the process for upgrading Universal Type Server from all versions of 6.x and 7.x to 7.x.